Adjustment of rear wiper armInspect the wiping area and stationary position of the wiperblade.Tightening Torque: 4 - 7 N·mBE–38REAR WIPER MOTORUnit inspection1. Remove the back door trim.NOTE:∑ See BO section of service manual.2. Connect the battery negative terminal (–) to the wipermotor body. Also connect the battery negative terminal tothe motor connector (–) and battery positive terminal (+) tothe motor connector (+), as indicated in the right figure.Ensure that the wiper motor functions.3. Ensure that the wiper motor stops at the automatic stop-ping position when the battery negative (–) terminal is dis-connected from the wiper motor negative (–) connector.REAR WIPER SWITCHUnit inspection1. Push the switch from back side while releasing the lock ofthe switch, remove the switch toward your side.2. Disconnect the connector.3. Ensure that continuity exists between the respective termi-nals, as indicated in the table below.135Defogger line +10–0Projection zone f50Center lineI29 I30Rear wiper motorI54I28Z18I31JBE00111-01609JBE00112-01610JBE00113-01611JBE00114-01612JBE00000-01613OFFWiper ONWasher ONZ18 I31 I28 I54
