8/9Breadcrumb Field code Setting name Range, stepDefault valueDate ValueField settings table Installer setting at variance withdefault valueA.8 [A-02] 0 (*5)1 (*6)A.8 [A-03] 0A.8 [A-04] 0A.8 [B-00] 0A.8 [B-01] 0A.8 [B-02] 0A.8 [B-03] 0A.8 [B-04] 0A.8 [C-00] R/W 0: Solar priority1: Heat pump priorityA.8 [C-01] 0A.8 [C-02] R/W 0: No1: Bivalent2: -3: -A.8 [C-03] R/W -25~25°C, step: 1°C0°CA.8 [C-04] R/W 2~10°C, step: 1°C3°CA.8 [C-05] R/W 1: Thermo ON/OFF2: C/H requestA.8 [C-06] R/W 0: -1: Thermo ON/OFF2: C/H requestA.8 [C-07] R/W 0: LWT control1: Ext RT control2: RT controlA.8 [C-08] R/W 0: No1: Outdoor sensor2: Room sensorA.8 [C-09] R/W 0: Normally open1: Normally closedA.8 [C-0A] 0A.8 [C-0C] R/W 0~70A.8 [C-0D] R/W 0~70A.8 [C-0E] R/W 0~70A.8 [D-00] R/W 0: None1: BSH only2: BUH only3: All heatersA.8 [D-01] R/W 0: No1: Open tariff2: Closed tariff3: ThermostatA.8 [D-02] R/W 0~40: No1: Secondary rtrn2: Disinf. shuntA.8 [D-03] R/W 0: Disabled1: Enabled, shift 2°C (from -2 to 2°C)2: Enabled, shift 4°C (from -2 to 2°C)3: Enabled, shift 2°C (from -4 to 4°C)4: Enabled, shift 4°C (from -4 to 4°C)A.8 [D-04] R/W 0: No1: Pwr consmp ctrlA.8 [D-05] R/W 0: Forced off1: As normalA.8 [D-07] R/W 0: No1: YesA.8 [D-08] R/W 0: No1: 0,1 pulse/kWh2: 1 pulse/kWh3: 10 pulse/kWh4: 100 pulse/kWh5: 1000 pulse/kWhA.8 [D-09] R/W 0: No1: 0,1 pulse/kWh2: 1 pulse/kWh3: 10 pulse/kWh4: 100 pulse/kWh5: 1000 pulse/kWhA.8 [D-0A] 0A.8 [D-0B] 2A.8 [D-0C] R/W 0~490A.8 [D-0D] R/W 0~490A.8 [D-0E] R/W 0~490A.8 [E-00] R/O 0~50: LT splitA.8 [E-01] R/O 0: 81: 16A.8 [E-02] R/O 0: Type 11: Type 2A.8 [E-03] R/O 0: No BUH1: 1 step2: 2 stepsA.8 [E-04] R/O 0: No1: YesA.8 [E-05] R/W 0: No (*1)1: Yes (*2)A.8 [E-06] R/O 0: No1: YesA.8 [E-07] R/W 0~60: Type 1 (*1)1: Type 2 (*2)A.8 [E-08] R/W 0: Disabled (*6)1: Enabled (*5)Forced off contact typeWhat is the number of backup heater steps?Is the power saving function available on the outdoor unit?Can the system prepare domestic hot water?Is a DHW tank installed in the system?What kind of DHW tank is installed?Power saving function for outdoor unit.What is the high electricity price (Do not use)What is the medium electricity price (Do not use)What is the low electricity price (Do not use)Which type of unit is installed?Which type of compressor is installed?What is the indoor unit software type?Is the pump allowed to run if prefer. kWh rate PS is cut?Is a solar kit connected?Is an external kWh meter used for power measurement?Is an external kWh meter used for power measurement?----Low electricity price decimal (Do not use)Which heaters are permitted if prefer. kWh rate PS is cut?Which type of DHW pump is installed?Leaving water temperature compensation around 0°C.Is a demand PCB connected?What is the unit control method in space operation?Which type of external sensor is installed?What is the required alarm output contact type?--High electricity price decimal (Do not use)Medium electricity price decimal (Do not use)--Is an external backup heat source connected?Bivalent activation temperature.Bivalent hysteresis temperature.What is the thermo request contact type for the main zone?What is the thermo request contact type for the add. zone?----------Domestic heating water priority.------4P383508-1B - 2017.04(*1) *HB*_(*2) *HV*_(*3) *3V_(*4) *9W_(*5) *04/08*_(*6) *11/16*