Installation and operation manual10 RXYQQ8~20T7Y1BVRV IV System Air Conditioner4P345099-1 – 2013.04 The installation space required on these drawings are for fullload heating operation without considering possible iceaccumulation.If the location of the installation is in a cold climate, then alldimensions above should be >500 mm to avoid accumulation ofice in between the outdoor units.8. Inspecting, handling and unpackingthe unit8.1. InspectionAt delivery, the unit must be checked and any damage must bereported immediately to the carrier's claims agent.8.2. Handling1 When handling the unit, take into account the following:Fragile, handle the unit with care.Keep the unit upright in order to avoid compressordamage.2 Choose on beforehand the path along which the unit is to bebrought in.3 Bring the unit as close as possible to its final installation positionin its original package to prevent damage during transport.1 Packaging material2 Belt sling3 Opening4 Protector4 Lift the unit preferably with a crane and 2 belts of at least 8 mlong as shown in the figure above.Always use protectors to prevent belt damage and pay attentionto the position of the unit's centre of gravity.A forklift can only be used for transport as long as the unit remains onits pallet as shown above.8.3. UnpackingRelief the unit from its packing material:Take care not to damage the unit when removing the shrink foil with acutter.1 Remove the 4 bolts fixing the unit to its pallet.2 Make sure that all accessories as mentioned in"4.1. Accessories supplied with this unit" on page 4 are availablein the unit.8.4. Installing the unitMake sure the unit is installed level on a sufficiently strong base toprevent vibration and noise.X Not allowedO Allowed The height of the foundation must at least be 150 mm from thefloor.In heavy snowfall areas, this height should be increased,depending on the installation place and condition. The unit must be installed on a solid longitudinal foundation(steel beam frame or concrete) and make sure the base underthe unit is larger than the grey marked area.INFORMATIONThe service space dimensions in above figure are basedon cooling operation at 35°C ambient temperature(standard conditions).INFORMATIONFurther specifications can be found in the technicalengineering data.NOTICEUse a belt sling of ≤20 mm wide that adequately bears theweight of the unit.44224331CAUTIONTo avoid injury, do not touch the air inlet or aluminium finsof the unit.WARNINGTear apart and throw away plastic packaging bags so thatchildren will not play with them. Children playing withplastic bags face danger of death by suffocation.NOTICEWhen the installation height of the unit needs to beincreased, do not use stands to only support the corners.RXYQQ14~20RXYQQ8~12PPPP