Test Operation SiE33-00376 General Information4.9 Wiring Check OperationIf within 12 hours of stopping cooling or heating, be sure to run all indoor units in the system you want tocheck in the fan mode for about 60 minutes in order to prevent mis-detection.Operation Method 1. In the monitor mode, check the number of connected indoor units. (See monitor mode.)2. Push and hold the WIRING CHECK button (BS4) for 5 seconds to perform wiring check operation.While running, TEST (H2P) lights and goes off when finished.If TEST (H2P) flickers (wiring check operation failure), push and hold the RESET button (BS5) for 5seconds, and then repeat the procedure from the beginning.3. About 1 minute after you finish running the system, once again check the number of connected indoorunits in the monitor mode and make sure the number agrees with the first time you checked. If not, itindicates that there is a wiring mistake. Fix the wiring of the indoor unit whose remote control displays“UF” when its ON/OFF switch is turned ON.Note: Other settings are not accepted during wiring check operation.Si33-003.book Page 76 Monday, June 25, 2001 9:06 AMВсе каталоги и инструкции здесь: http://splitoff.ru/tehn-doc.html
