Danfoss FC 300 Programming Manual

Also see for FC 300: Operating instructions Instruction manual Design guide Design guide Design guide

Danfoss FC 300 Programming Manual Manual pdf 110 page image

8-55 Set-up SelectSelect control of the frequency converter set-up selection via the terminals (digital input) and/or via the fieldbus.[0] Digital input[1] Bus Activates the set-up selection via the serial communication port or fieldbus option.[2] Logic AND Activates the set-up selection via the fieldbus/serial communication port, AND additionally via one ofthe digital inputs.[3] * Logic OR Activate the set-up selection via the fieldbus/serial communication port OR via one of the digital inputs.NB!This parameter is active only whenpar. 8-01 Control Site is set to [0]Digital and control word.8-56 Preset Reference SelectSelect control of the frequency converter Preset Reference selection via the terminals (digital input) and/or via thefieldbus.[0] Digital input[1] Bus Activates Preset Reference selection via the serial communication port or fieldbus option.[2] Logic AND Activates Preset Reference selection via the fieldbus/serial communication port, AND additionally viaone of the digital inputs.[3] * Logic OR Activates the Preset Reference selection via the fieldbus/serial communication port OR via one of thedigital inputs.NB!This parameter is active only whenpar. 8-01 Control Site is set to [0]Digital and control word.2.11.6. 8-9* Bus JogParameters for configuring the Bus Jog.8-90 Bus Jog 1 SpeedRange: Function:100 RPM* [0 - par. 4-13 RPM] Enter the jog speed. This is a fixed jog speed activated via the serial port or fieldbus option.8-91 Bus Jog 2 SpeedRange: Function:200 RPM* [0 - par. 4-13 RPM] Enter the jog speed. This is a fixed jog speed activated via the serial port or fieldbus option.2.12. Parameters: Profibus2.12.1. 9-** ProfibusParameter group for all Profibus-specific parameters.9-00 SetpointRange: Function:0 * [0-65535] This parameter receives cyclical reference from a Master Class 2. If the control priority is set to Master Class 2,the reference for the frequency converter is taken from this parameter, whereas the cyclical reference will beignored.2. How to Programme FC 300 Programming Guide110 MG.33.M3.02 - VLT ® is a registered Danfoss trademark2