Danfoss FC 300 Programming Manual

Also see for FC 300: Operating instructions Instruction manual Design guide Design guide Design guide

Danfoss FC 300 Programming Manual Manual pdf 157 page image

0 * [0 - 9999] View a list of the parameters that have been changed from their default setting. The list ends with 0. Changesmay not be visible until up to 30 seconds after implementation.15-99 Parameter MetadataArray [30]0 * [0 - 9999] This parameter contains data used by the MCT10 software tool.2.17. Parameters: Data Read-outs2.17.1. 16-** Data ReadoutsParameter group for data read-outs, e.g. actual references, voltages, control, alarm, warning and status words.2.17.2. 16-0* General StatusParameters for reading the general status, e.g. the calculated reference, the active control word, status.16-00 Control WordRange: Function:0 * [0 - FFFF] View the Control word sent from the frequency converter via the serial communication port in hex code.16-01 Reference [Unit]Range: Function:0.000* [-999999.000 -999999.000]View the present reference value applied on impulse or analog basis in the unit resulting from the configurationselected in par. 1-00 (Hz, Nm or RPM).16-02 Reference %Range: Function:0%* [-200 to 200 %] View the total reference. The total reference is the sum of digital, analog, preset, bus, and freeze references,plus catch-up and slow-down.16-03 Status WordRange: Function:0 * [0 - FFFF] View the Status word sent from the frequency converter via the serial communication port in hex code.16-05 Main Actual Value [%]Range: Function:0%* [-100 to +100%] View the two-byte word sent with the Status word to the bus Master reporting the Main Actual Value.16-09 Custom ReadoutRange: Function:0.00 unit* [x.xx - x.xx unit] View the value of custom readout from par. 0-30 to par. 0-322.17.3. 16-1* Motor StatusParameters for reading the motor status values.FC 300 Programming Guide 2. How to ProgrammeMG.33.M3.02 - VLT ® is a registered Danfoss trademark 1572