Danfoss FC 300 Series Programming Manual

Also see for VLT AutomationDrive FC 301: Installation guide Operating guide Installation guide Design guide Installation guide

Contents

Danfoss FC 300 Series Programming Manual Manual pdf 124 page image

3.13 Parameters: 12-** Ethernet3.13.1 12-0* IP Settings12-00 IP Address AssignmentOption: Function:Selects the IP address assignment method.[0] * Manual The IP address can be set in par. 12-01 IP Address.[1] DHCP The IP address is assigned via DHCP server.[2] BOOTP The IP address is assigned via BOOTP server.12-01 IP AddressRange: Function:[000.000.000.000–255.255.255.255]Configure the IP address of theoption. Read-only if par. 12-00 set toDHCP or BOOTP.12-02 Subnet MaskRange: Function:[000.000.000.000–255.255.255.255]Configure the IP subnet mask of theoption. Read-only if par. 12-00 set toDHCP or BOOTP.12-03 Default GatewayRange: Function:[000.000.000.000–255.255.255.255]Configure the IP default gateway ofthe option. Read-only if par. 12-00 setto DHCP or BOOTP.12-04 DHCP ServerRange: Function:[000.000.000.000 –255.255.255.255]Read only. Displays the IP addressof the found DHCP or BOOTP server.NOTE!A power cycle is necessary after setting the IP parametersmanually.12-05 Lease ExpiresRange: Function:[dd:hh:mm:ss] Read only. Displays the lease time left for thecurrent DHCP-assigned IP address.12-06 Name ServersOption: Function:IP addresses of Domain Name Servers. Can beautomatically assigned when using DHCP.[0] Primary DNS[1] Secondary DNS12-07 Domain NameRange: Function:Blank [0–19 characters] Domain name of the attached network.Can be automatically assigned whenusing DHCP.12-08 Host NameRange: Function:Blank [0–19 characters] Logical (given) name of option.12-09 Physical AddressRange: Function:[00:1B:08:00:00:00–00:1B:08:FF:FF:FF]Read only: Displays the Physical (MAC)address of the option.3.13.2 12-1* Eth link par12-1* Ethernet Link ParaOption: Function:Applies for whole par. group.[0] Port 1[1] Port 212-10 Link StatusOption: Function:Read only. Displays the link status of the Ethernetports.[0] No link[1] Link12-11 Link DurationOption: Function:Link Duration Port 1(dd:hh:mm:ss)Read only. Displays the duration ofthe present link on each port indd:hh:mm:ss.12-12 Auto NegotiationOption: Function:Configures Auto Negotiation of Ethernet link parametersfor each port, ON or OFF.[0] Off Link Speed and Link Duplex can be configured in par. 12-13and 12-14.[1] OnParameter Descriptions FC 300 Programming Guide3-102 MG.33.MA.22 - VLT® is a registered Danfoss trademark3