Danfoss FC 300 Series Programming Manual

Also see for VLT AutomationDrive FC 301: Installation guide Operating guide Installation guide Design guide Installation guide

Contents

Danfoss FC 300 Series Programming Manual Manual pdf 8 page image

“Protection mode” can be disabled by setting 14-26 TripDelay at Inverter Fault to zero which means that theadjustable frequency drive will trip immediately if one of thehardware limits is exceeded.NOTE!It is recommended to disable protection mode in hoistingapplications (14-26 Trip Delay at Inverter Fault = 0)1.1.5 Electrical Wiring - Control Cables ! " # $% " $% " $% "% $%$% ! ! ! ! ! &!' !" &!' % % ())(&!' % ( %*+, ( %-./!0(0/*+&10))(20+ 3.4 5&402-60/*+2.1-60/ %.2278%6*1!5 - 0+&7-9 .12.1/07&8/07&8-1-/+10/:&!0$ $ /&,0/04*41-/;;;Figure 1.1 Diagram showing all electrical terminals without options.Terminal 37 is the input to be used for Safe Stop. For instructions on Safe Stop installation please, refer to the section Safe Stop Installation ofthe Design Guide.* Terminal 37 is not included in FC 301 (Except FC 301 A1, which includes Safe Stop).Terminal 29 and Relay 2, are not included in FC 301.Introduction FC 300 Programming Guide1-6 MG.33.MA.22 - VLT® is a registered Danfoss trademark1