Danfoss VLT AQUA Drive FC 200 Instruction Manual

Also see for VLT AQUA Drive FC 200: Manual Design guide Service manual Instruction manual Operating instructions

Contents

Danfoss VLT AQUA Drive FC 200 Instruction Manual Manual pdf 32 page image

4 How to Install4.1 Electrical Installation4.1.1 Power ConnectionsCabling and FusingNOTE!Cables GeneralAll cabling must comply with national and localregulations on cable cross-sections and ambienttemperature. UL applications require 167°F [75°C] copperconductors. 167°F [75°C] and 194°F [90°C] copperconductors are thermally acceptable for the adjustablefrequency drive to use in non-UL applications.The power cable connections are situated as shown below.Dimensioning of cable cross-section must be done inaccordance with the current ratings and local legislation.See7.1 General Specifications for details.For protection please see fuse in the tables of the fusesection. Always ensure that proper fusing is doneaccording to local regulations.6 Phasepowerinput130BB693.1091-1 (L1-1)92-1 (L2-1)93-1 (L3-1)91-292-293-295 PE(L2-2)(L1-2)(L3-2)NOTE!Use a shielded/armored motor cable to comply with EMCemission specifications. For more information, see EMCspecifications in the /FC 300Design Guide.See 7.1 General Specifications for correct dimensioning ofmotor cable cross-section and length.How to Install VLT AQUA 12-Pulse High Power Instruction ManualMG.20.Y1.22 - VLT® is a registered Danfoss trademark 4-14 4