Danfoss VLT AQUA Drive FC 200 Instruction Manual

Also see for VLT AQUA Drive FC 200: Manual Design guide Service manual Instruction manual Operating instructions

Contents

Danfoss VLT AQUA Drive FC 200 Instruction Manual Manual pdf 54 page image

Step 3. Activate the Auto-tunePerforming an auto tune will ensure optimumperformance. The auto tune measures the values from themotor model equivalent diagram.1. Activate the auto tune 1-29 Automatic MotorAdaptation (AMA).2. Choose between complete or reduced auto-tune.If a sine-wave filter is mounted, run only thereduced auto-tune, or remove the sine-wave filterand run complete Auto-tune.3. Press the [OK] key. The display shows “Press[Hand] to start”.4. Press the [Hand] key. A progress bar indicates ifthe auto tune is in progress.Stop the Auto Tune during operation1. Press the [OFF] key - the adjustable frequencydrive enters into alarm mode and the displayshows that the Auto Tune was terminated by theuser.Successful Auto Tune1. The display shows “Press [OK] to finish AutoTune”.2. Press the [OK] key to exit the Auto Tune state.Unsuccessful Auto Tune1. The adjustable frequency drive enters into alarmmode. A description of the alarm can be found inthe Warnings and Alarms chapter.2. "Report Value" in the [Alarm Log] shows the lastmeasuring sequence carried out by the AutoTune before the adjustable frequency driveentered alarm mode. This number along with thedescription of the alarm will assist you in trouble-shooting. If you contact Danfoss for service, makesure to mention the number and alarmdescription.NOTE!Unsuccessful auto-tune is often caused by incorrectlyentering motor nameplate data or a too big differencebetween the motor power size and the adjustablefrequency drive power size.Step 4. Set speed limit and accel/decel times.3-02 Minimum Reference3-03 Maximum ReferenceTable 4.11 Set up the desired limits for speed and ramp time.4-11 Motor Speed Low Limit [RPM] or 4-12 Motor Speed Low Limit[Hz]4-13 Motor Speed High Limit [RPM] or 4-14 Motor Speed High Limit[Hz]3-41 Ramp 1 Ramp-up Time3-42 Ramp 1 Ramp-down Time4.5 Additional Connections4.5.1 Parallel Connection of MotorsThe adjustable frequency drive can control several parallel-connected motors. The total current consumption of themotors must not exceed the rated output current IM,N forthe adjustable frequency drive.NOTE!Installation with cables connected in a common joint, as inthe figure below, is only recommended for short cablelengths.NOTE!When motors are connected in parallel, 1-29 AutomaticMotor Adaptation (AMA) cannot be used.NOTE!The electronic thermal overload of the adjustablefrequency drive cannot be used as motor protection forthe individual motor in systems with parallel-connectedmotors. Provide further motor protection with, forexample, thermistors in each motor or individual thermalrelays (circuit breakers are not suitable for protection).How to Install VLT AQUA 12-Pulse High Power Instruction ManualMG.20.Y1.22 - VLT® is a registered Danfoss trademark 4-234 4