Danfoss VLT DriveMotor FCP 106 Programming Manual

Also see for VLT DriveMotor FCM 106: Operating instructions Operating instructions Design guide Design guide Installation instructions

Contents

Danfoss VLT DriveMotor FCP 106 Programming Manual Manual pdf 66 page image

4.8 Main Menu - Communications andOptions - Group 84.8.1 8-0* General Settings8-01 Control SiteOption: Function:Select [0] Digital and ctrl.word for usingdigital input and control word. Select [1]Digital only to use digital inputs only. Select[2] Control word only to use control wordonly. This parameter overrules settings inparameter 8-50 Coasting Select toparameter 8-56 Preset Reference Select.[0]*Digital andctrl.wordControl by using both digital input andcontrol word.[1] Digital only Control by using digital inputs only.[2] ControlwordonlyControl by using control word only.8-02 Control SourceOption: Function:NOTICEThis parameter cannot be adjusted whilethe motor is running.Select the source of the control word.[0] None[1] * FC Port8-03 Control Timeout TimeRange: Function:1 s* [0.1 -6500 s]Enter the maximum time expected to passbetween the reception of 2 consecutivetelegrams. If this time is exceeded, it indicatesthat the serial communication has stopped. Thefunction selected in parameter 8-04 ControlTimeout Function Control Time-out Function iscarried out.8-04 Control Timeout FunctionOption: Function:Select the timeout function. The time-out function isactivated when the control word fails to be updatedwithin the time period specified inparameter 8-03 Control Timeout Time.[0] * Off4.8.2 8-3* FC Port Settings8-30 ProtocolOption: Function:Select the protocol for the integrated RS-485port. Change of settings in may change thebaud rate.[0] FC Communication according to the FC Protocol.[2] ModbusRTUCommunication according to the Modbus RTUprotocol.[3] Metasys N2 Communication protocol. The N2 softwareprotocol is designed to accommodate theunique properties each device may have.[5] BACNet8-31 AddressRange: Function:1* [ 0.0 - 247 ] Enter the address for the RS-485 port. Validrange: 1-126 for FC-bus OR 1-247 for Modbus.8-32 Baud RateOption: Function:Select the baud rate for the RS-485 portDefault refers to the FC Protocol. ChangingProtocol in 8-30 Protocol may change the BaudRate.Changing Protocol in 8-30 Protocol maychange the Baud Rate.[0] 2400 Baud[1] 4800 Baud[2] 9600 Baud Default setting for• Modbus RTU• BACnet• Metasys N2[3] 19200 Baud[4] 38400 Baud[5] 57600 Baud[6] 76800 Baud[7] 115200 Baud8-33 Parity / Stop BitsOption: Function:Parity and stop bits for the protocolusing the FC Port. For some of theprotocols, not all options are available.Default refers to the FC Protocol.Changing Protocol in 8-30 Protocolmay change the Baud Rate.[0] Even Parity, 1 StopBit[1] Odd Parity, 1 StopBitParameters VLT® DriveMotor FCP 106 and FCM 106 Programming Guide64 MG03N102 - Rev. 2013-12-0244