12 Installing the Hardware ComponentsInstalling the Card Hopper1. If present, remove styrofoam packing foam from inside the card hopper.2. Insert the card hopper hooks into the receptacle slots on the printer.3. Slide the card hopper down until it clicks into place.Installing the Card StackerAs completed cards exit the printer or laminator, they are collected in the card stacker. Install thecard stacker below the card out slot on the left side of the printer or the laminator (if used).Card Stacker on SR200 or SR300 PrinterWhen no laminator is used, place the stacker tabs into the attachment slots on the side of theprinter. Be sure to hang the card stacker on the attachment slots, not on the card out slot.The card hopper can hold up to 100, 0.030 inch (0.75 mm) thick cards.The card stacker can hold up to 100 0.030 inch (0.75mm) thick cards.Card Out Slot
