SR200 & SR300 Card Printers and LM200 & LM200 Laminators Installation Guide 13Card Stacker on Optional LaminatorWhen an LM200 or LM300 laminator is installed, hang the card stacker on the laminator’s cardstacker receptacle. Be sure to hang the card stacker on the attachment slots, not on the card outslot.Plugging in the Power Cord(s)Use this procedure to connect the provided power cord to the printer, and to the laminator (ifused).1. Verify the plug type. The power cords vary according to model and country of purchase.2. Plug the power cord into the power receptacle at the back of the printer.Warning: Always use a grounded power outlet that is not shared with other electricalequipment.Caution: Use an Automatic Voltage Regulator (AVR) if there is a possibility of voltagefluctuations. Use an uninterruptible power source rather than an AVR if there is apossibility of frequent power loss.Card Out Slot
