Dedicated Micros DM18X Instruction Manual

Dedicated Micros DM18X Instruction Manual Manual pdf 13 page image

72.6 Connections• Connecting to the RS485/ 422The dome camera can be controlled remotely by an external device or control system, such as acontrol keyboard, using RS485 half-duplex, RS422 duplex or simplex serial communicationssignals. Connect Marked Rx+(Tx+), Rx-(Tx-) to Tx+ and Tx- of the RS485 control system.If control system is RS422, connect Rx+(Tx+), Rx-(Tx-) and Rx+, Rx- of the dome camera toRx+, Rx- and Tx+, Tx- of the control device respectively.• Connecting Video out connectorConnect the video out(BNC) connector to the monitor or video input.• Connecting AlarmsAL1 to 8 (Alarm In)You can use external devices to signal the dome camera to react on events. Mechanical orelectrical switches can be wired to the AL (Alarm In) and GND (Ground) connectors.. SeeChapter 3 — Program and Operation for configuring alarm input.GND (Ground)NOTE: All the connectors marked GND are common.Connect the ground side of the Alarm input and/or alarm output to the GND connector.NC(NO)1 TO 4 (Normal Close or Normal Open : Alarm Out)The dome camera can activate external devices such as buzzers or lights. Connect the device tothe NC(NO) (Alarm Out) and COM (Common) connectors. See Chapter 3 — Program andOperation for configuring alarm output.• Connecting the PowerConnect the power of AC 24V 850mA to the dome camera.Use certified / Listed Class 2 power supply transformer only.