Defender SN502-4CH Instruction Manual

Also see for SN502-4CH: Instruction manual Quick start guide

Contents

Defender SN502-4CH Instruction Manual Manual pdf 13 page image

SN502-4CH 10BASIC SETUPCONNECTING A MONITOR1. Connect a BNC to RCA connector to the top VIDEO OUTconnection on the back of the DVR.2. Plug the RCA cable into the BNC connector.3. Attach the other end of the RCA cable to a yellow RCAvideo input on your TV/monitor.4. Switch the TV/Monitor source to view the DVR.(Consult the TV/Monitor manual for instructions onhow to switch the video source)5. The bottom video out is for a second monitor. Pluggingan RCA cable into this video out would be the same asplugging it into the top video output.1. Insert the included power cord into the includedpower supply.2. Plug the power cord into a power outlet (surgeprotected power outlet recommended).3. Insert the power supply wire into the rear DC 12V porton the DVR.• After a few seconds the splash screen will appearand the DVR will start up.POWERING ON DVRCONNECTING A PTZ CAMERAThe SN502-4CH supports a 2 wire RS-485 connection fora PTZ camera to be connected (PTZ camera not included).Please see the PTZ camera manual for further instructionson required connections and settings.To connect a two PTZ camera:1. With a small flat head screwdriver, unscrew the screwon the top of the opening.2. Insert the wire into the hole below the top screw whileit is still unscrewed3. Re-tighten the top screw, this will lock the wire intoplace. Pull lightly on the wire to make sure it is secure.4. For further instruction on connecting your PTZ camera,please see the PTZ camera’s instruction manual.1.2.Connect to a power source to turn on DVRPlug in BNC to RCA connectorPlug RCA cable to BNC3.