Configuring the Network AddressDell 7330 Mono Laser Printer3-8Manually Setting the Printer’s IP AddressNote: Verify that your computer has a properly configured IP address for your network.Contact your network administrator for more information.If you are on a network without a DHCP server, or in an environment where the networkadministrator assigns printer IP addresses, you can use this method to manually set the IPaddress. Manually setting the IP address overrides DHCP and AutoIP. Alternatively, if you arein a small office with a single PC and use a dialup modem connection, you can manually setthe IP address.Using the Control PanelTo manually set the IP address:1. On the control panel, select Printer Setup, and then press the OK button.2. Select Connection Setup, and then press the OK button.3. Select Network Setup, and then press the OK button.4. Select TCP/IPv4 Setup, and then press the OK button.5. Select DHCP/BOOTP, and then press the OK button to select Off.6. Select IPv4 Address, and then press the OK button.7. Enter the printer’s IP address, and then press the OK button.Information Required for Manual IP AddressingInformation CommentsInternet Protocol (IP) address of the printer Format is xxx.xxx.xxx.xxx, where xxx representsa decimal number from 0–255.Network Mask If you are unsure, leave this blank; the printerchooses an appropriate mask.Default Router/Gateway address Router address is required to communicate withthe host device from anywhere other than thelocal network segment.
