Use ToPS SmartSwitchOnOffSet the printer to automatically switch to PS emulation when a print job requires it,regardless of the default printer language.Notes:• On is the factory default setting.• If PS SmartSwitch is disabled, then the printer does not examine incomingdata and it uses the default printer language specified in the Setup menu.NPA ModeOffAutoSet the printer to perform the special processing required for bidirectionalcommunication following the conventions defined by the NPA protocol.Notes:• Auto is the factory default setting.• Changing this setting from the printer control panel and then exiting themenus causes the printer to restart. The menu selection is then updated.Network BufferDisabledAuto3KB to [maximum size allowed]Set the size of the network input buffer.Notes:• Auto is the factory default setting.• The value can be changed in 1‑KB increments.• The maximum size allowed depends on the amount of memory in the printer,the size of the other link buffers, and whether Resource Save is set to On orOff.• To increase the maximum size range for the Network Buffer, disable orreduce the size of the parallel, serial, and USB buffers.• Changing this setting from the printer control panel and then exiting themenus causes the printer to restart. The menu selection is then updated.Mac Binary PSOnOffAutoSet the printer to process Macintosh binary PostScript print jobs.Notes:• Auto is the factory default setting.• Off filters print jobs using the standard protocol.• On processes raw binary PostScript print jobs.Reports menuTo access the menu, navigate to any of the following:• Network/Ports menu > Networks/Ports > Standard Network > Standard Network Setup > Reports• Network/Ports menu > Networks/Ports > Network [x] > Network [x] Setup > ReportsUse ToPrint Setup Page Print a report containing information about the network printer settings, such as the TCP/IP address.Understanding the printer menus 62
