Dell Dimension 9200C Owner's Manual

Also see for Dimension 9200C: Owner's manual Service manual

Contents

42 Solving ProblemsMouse ProblemsCAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in theProduct Information Guide.IF Y O U E X P E R I E N C E O T H E R M E M O R Y P R O B L E M S —• Reseat the memory modules (see "Memory" on page 66) to ensure that your computer is successfullycommunicating with the memory.• Ensure that you are following the memory installation guidelines (see "Installing Memory" on page 68).• Ensure that the memory you are using is supported by your computer. For more information about thetype of memory supported by your computer, see "Memory" on page 97.• Run the Dell Diagnostics (see "Dell Diagnostics" on page 52).CL E A N T H E M O U S E — See "Mouse" on page 110.CH E C K T H E M O U S E C A B L E —• Ensure that the cable is not damaged or frayed and check cable connectors for bent or broken pins.Straighten any bent pins.• Remove any mouse extension cables, and connect the mouse directly to the computer.• Verify that the mouse cable is connected as shown on the setup diagram for your computer.RE S T A R T T H E C O M P U T E R —1 Simultaneously press to display the Start menu.2 Press <u>, press the up- and down-arrow keys to highlight Shut down or Turn Off, and then press.3 After the computer turns off, reconnect the mouse cable as shown on the setup diagram.4 Turn on the computer.TE S T T H E M O U S E — Connect a properly working mouse to the computer, then try using the mouse.CH E C K T H E M O U S E S E T T I N G S —1 Click Start, click Control Panel, and then click Printers and Other Hardware.2 Click Mouse.3 Adjust the settings, as needed.RE I N S T A L L T H E M O U S E D R I V E R — See "Reinstalling Drivers" on page 55.book.book Page 42 Wednesday, August 9, 2006 2:32 PM