Dell Dimension 9200C Owner's Manual

Also see for Dimension 9200C: Owner's manual Service manual

Contents

Removing and Installing Parts 7310 Close the card retention door by snapping it into place.NOTICE: Do not route card cables over or behind the cards. Cables routed over the cards can prevent thecomputer cover from closing properly or cause damage to the equipment.11 Connect any cables that should be attached to the card.See the documentation that came with the card for information about the card’s cable connections.NOTICE: To connect a network cable, first plug the cable into the network device and then plug it into the computer.12 Replace the computer cover (see "Replacing the Computer Cover" on page 96), reconnect thecomputer and devices to electrical outlets, and then turn them on.13 Install any drivers required for the card as described in the card documentation.1 retention arm 2 PCI Express card3 edge connector 4 card connector3421book.book Page 73 Wednesday, August 9, 2006 2:32 PM