Dell Dimension DMC Owner's Manual

Also see for Dimension 4600 Series: Quick setup guide Owner's manual Removal guide Service manual Installation manual

Contents

Dell Dimension DMC Owner's Manual Manual pdf 66 page image

66 Adding Partsw w w . d e l l . c o m | s u p p o r t . d e l l . c o m 14 Replace the computer cover.NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it intothe computer.15 Connect your computer and devices to electrical outlets, and turn them on.See the documentation that came with the drive for instructions on installing any softwarerequired for drive operation.Adding a Floppy DriveCAUTION: Before you begin any of the procedures in this section, follow the safety instructionslocated in the Product Information Guide.1 Shut down the computer through the Start menu (see page 18).2 Ensure that your computer and attached devices are turned off. If your computer andattached devices did not automatically turn off when you shut down your computer, turnthem off now.NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug itfrom the network wall jack.3 Disconnect any telephone or telecommunication lines from the computer.4 Disconnect your computer and all attached devices from their electrical outlets, and thenpress the power button to ground the system board.CAUTION: To guard against electrical shock, always unplug your computer from the electrical outletbefore opening the cover.5 Remove the computer cover (see page 55).6 Release and remove the front panel:a Push the release lever to release the top tab.b Reach inside the computer and push the bottom tab towards you to release it (the middletab releases automatically).c Rotate the front panel to separate it from the side hinges.