Dell E1200i ExaScale Installation Manual

Also see for E1200i ExaScale: Configuration guide

Contents

Dell E1200i ExaScale Installation Manual Manual pdf 56 page image

56 | Powering Upw w w . d e l l . c o m | s u p p o r t . d e l l . c o mSupplying Power - ACTo turn the chassis power off, flip the On/Standby switch to the Standby position.NOTE: The AC power supplies status LEDs will remain lit and the power supply fans will continue to operate,even though DC power to the backplane has been turned off.Supplying Power - DCBooting to the CLI PromptAfter you supply power to the system, the following should occur:• During bootup, power is removed temporarily from all line cards and SFM3s. This is expected behavior.• Both fan trays should be operating. The fan tray and SFM3 LEDs might flash amber during bootup.Step Task1 Flip the REMOTE power switch to the ON position.2 Remove the card from the box. Remove the card from the anti-static bag.3 Flip the On/Standby switch to the ON position.4 The Status LED for each power supply should be green (online). If a power supply’s LED is not lit or is amber:• Ensure that the unit is properly installed.• Verify the power source.• If the power supply’s LED remains unlit, power off the remote power source and replace the unit.5 Both fan tray LEDs should be green (they may flash green, or amber during a long boot). Verify that air is flowingthrough the chassis. If a fan tray is not operating properly or air is not flowing through the chassis:• Power off the chassis at the remote power source.• Ensure that the fan tray is properly installed.• Verify the power source.• If the fan tray LED remains unlit on power-up, replace the fan tray.Step Task1 Flip the REMOTE power switch to the ON position.2 Remove the card from the box. Remove the card from the anti-static bag.3 The Status LED for each power supply should be green (online). If a power supply’s LED is not lit or is amber:• Ensure that the unit is properly installed.• Verify the power source.• If the power supply’s LED remains unlit, power off the remote power source and replace the unit.4 Both fan tray LEDs should be green (they may flash green, or amber during a long boot). Verify that air is flowingthrough the chassis. If a fan tray is not operating properly or air is not flowing through the chassis:• Power off the chassis at the remote power source.• Ensure that the fan tray is properly installed.• Verify the power source.• If the fan tray LED remains unlit on power-up, replace the fan tray.