Dell E1200i ExaScale Installation Manual

Also see for E1200i ExaScale: Configuration guide

Contents

Dell E1200i ExaScale Installation Manual Manual pdf 68 page image

68 | Using a Flash Memory Cardw w w . d e l l . c o m | s u p p o r t . d e l l . c o m To install the flash memory card:To install the flash memory card:1 Hold the flash card vertically with the slanted edge on top and the connector end facing the slot.2 Insert the flash card into the primary RPM flash slot until the card is completely seated with theconnectors at the rear of the slot. Do not force the card into the slot. The slot is specifically tooled toprevent improper installation.3 The In Use LEDs only illuminate during read or write operations.Removing the External Flash Memory CardTo remove the flash memory card:To remove the flash memory card:1 Gently depress the flash card in the slot. The card should partially pop out of the slot.2 Remove the card and place it in an antistatic bag.Formatting an External Flash CardNew external flash cards must be formatted in the E1200 before use.Flash cards used on systems other than the E1200 as well as cards formatted on PCs must be reformattedin the E1200 flash slot before they can be used. Similar to formatting a new diskette, formatting erases allinformation stored on the flash card.Step Task1 Press the ejector button to ensure it is in the extended position.Hold the flash card vertically (with the manufacturer’s label onthe left and the barcode on the right).2 Gently insert the flash card into the primary RPM flash slotuntil the card is flush with the front panel. Do not force theflash card into the slot.3 The In Use LED illuminates only during read or writeoperations.Step Task1 Gently depress the flash card in the slot. The card should partially pop out of the slot.2 Remove the card and place it in an antistatic bag.F