System Specifications | 83Environmental SpecificationsAgency ComplianceThe E1200 is designed to comply with the following safety and agency requirements.USA Federal Communications Commission (FCC) StatementThis equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. Theselimits are designated to provide reasonable protection against harmful interference when the equipment is operated in a commercialenvironment. This equipment generates, uses, and can radiate radio frequency energy. If it is not installed and used in accordance to theinstructions, it may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to causeharmful interference, in which case users will be required to take whatever measures necessary to correct the interference at their own expense.Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. Dell Force10 is not responsible forany radio or television interference caused by using other than recommended cables and connectors or by unauthorized changes or modificationsin the equipment. Unauthorized changes or modification could void the user’s authority to operate the equipment.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not causeharmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.Canadian Department of Communication StatementEuropean Union EMC Directive Conformance StatementThis product is in conformity with the protection requirements of EU Council Directive 2004/108/EC on the approximation of the laws of theMember States relating to electromagnetic compatibility. Dell Force10 cannot accept responsibility for any failure to satisfy the protectionrequirements resulting from a non-recommended modification of this product, including the fitting of non-Dell Force10 option cards.This product has been tested and found to comply with the limits for Class A Information Technology Equipment according to CISPR 22/European Standard EN 55022. The limits for Class A equipment were derived for commercial and industrial environments to provide reasonableprotection against interference with licensed communication equipment.WARNING: This is a Class A product. In a domestic environment, this device may cause radio interference, inwhich case, the user may be required to take adequate measures.European Community ContactOperating SpecificationsTemperature 32° to 104°F (0° to 40°C)Maximum altitude No performance degradation to 10,000 feet (3,048 meters)Relative humidity 5 to 85 percent, noncondensingShock Designed to meet Telcordia GR-63 COREVibration Designed to meet Telcordia GR-63 CORENon-operatingTemperature -40° to 158°F (-40° to 70°C)Maximum altitude 15,000 feet (4,572 meters)Relative humidity 5 to 95 percent, noncondensingVibration Bellcore GR-63