Dell EMC PowerEdge R440 Installation And Service Manual

Also see for EMC PowerEdge R440: Installation and service manual Installation and service manual

Contents

Serial Communication detailsThe Serial Communication screen details are explained as follows:Option DescriptionSerialCommunication Selects serial communication devices (Serial Device 1 and Serial Device 2) in BIOS. BIOS console redirection canalso be enabled, and the port address can be specified. This option is set to Auto by default.Enables the COM port or Console Redirection options. This option is set to Off by default.Serial Port Address Enables you to set the port address for serial devices. This option is set to Serial Device1=COM2, Serial Device2=COM1 by default.NOTE: You can use only Serial Device 2 for the Serial Over LAN (SOL) feature. To use consoleredirection by SOL, configure the same port address for console redirection and the serial device.NOTE: Every time the system boots, the BIOS syncs the serial MUX setting saved in iDRAC. The serialMUX setting can independently be changed in iDRAC. Loading the BIOS default settings from withinthe BIOS setup utility may not always revert the serial MUX setting to the default setting of SerialDevice 1.External SerialConnector Enables you to associate the External Serial Connector to Serial Device 1, Serial Device 2, or the Remote AccessDevice by using this option. This option is set to Serial Device 1 by default.NOTE: Only Serial Device 2 can be used for Serial Over LAN (SOL). To use console redirection by SOL,configure the same port address for console redirection and the serial device.NOTE: Every time the system boots, the BIOS syncs the serial MUX setting saved in iDRAC. The serialMUX setting can independently be changed in iDRAC. Loading the BIOS default settings from withinthe BIOS setup utility may not always revert this setting to the default setting of Serial Device 1.Failsafe Baud Rate Specifies the failsafe baud rate for console redirection. The BIOS attempts to determine the baud rateautomatically. This failsafe baud rate is used only if the attempt fails, and the value must not be changed. Thisoption is set to 115200 by default.Remote TerminalTypeSets the remote console terminal type. This option is set to VT100/VT220 by default.Redirection AfterBootEnables or disables the BIOS console redirection when the operating system is loaded. This option is set toEnabled by default.System Profile SettingsYou can use the System Profile Settings screen to enable specific system performance settings such as power management.Viewing System Profile SettingsTo view the System Profile Settings screen, perform the following steps:1 Turn on, or restart your system.2 Press F2 immediately after you see the following message:F2 = System SetupNOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and thenrestart your system and try again.118 Pre-operating system management applications