Dell EMC PowerEdge R440 Installation And Service Manual

Also see for EMC PowerEdge R440: Installation and service manual Installation and service manual

Contents

Removing a memory modulePrerequisites1 Follow the safety guidelines listed in Safety instructions.2 Follow the procedure listed in Before working inside your system.3 If applicable, remove the air shroud.WARNING: Allow the memory modules to cool after you power off the system. Handle the memory modules by the card edgesand avoid touching the components or metallic contacts on the memory module.Steps1 Locate the appropriate memory module socket.CAUTION: Handle each memory module only by the card edges, ensuring not to touch the middle of the memorymodule or metallic contacts.2 Push the ejectors outward on both ends of the memory module socket to release the memory module from the socket.3 Lift and remove the memory module from the system.Figure 49. Removing a memory moduleNext step1 Install the memory module.Installing a memory modulePrerequisiteFollow the safety guidelines listed in Safety instructions.Steps1 Locate the appropriate memory module socket.CAUTION: Handle each memory module only by the card edges, ensuring not to touch the middle of the memorymodule or metallic contacts.CAUTION: To prevent damage to the memory module or the memory module socket during installation, do not bend orflex the memory module. You must insert both ends of the memory module simultaneously.2 Open the ejectors on the memory module socket outward to allow the memory module to be inserted into the socket.3 Align the edge connector of the memory module with the alignment key of the memory module socket, and insert the memory modulein the socket.Installing and removing system components 63