240 | Interfacesw w w . d e l l . c o m | s u p p o r t . d e l l . c o m Figure 13-17. Interface Range Prompt Excluding Duplicate EntriesExclude a Smaller Port RangeIf the interface range has multiple port ranges, the smaller port range is excluded from the prompt.Figure 13-18. Interface Range Prompt Excluding a Smaller Port RangeOverlap Port RangesIf overlapping port ranges are specified, the port range is extended to the smallest start port number andlargest end port number.Figure 13-19. Interface Range Prompt Including Overlapping Port RangesCommasThe example below shows how to use commas to add different interface types to the range, enabling allTen Gigabit Ethernet interfaces in the range 5/1 to 5/23 and both Ten Gigabit Ethernet interfaces 1/1 and 1/2.Figure 13-20. Multiple-Range Bulk Configuration Gigabit Ethernet and Ten-Gigabit EthernetAdd RangesThe example below shows how to use commas to add VLAN and port-channel interfaces to the range.FTOS(conf)#interface range vlan 1 , vlan 1 , vlan 3 , vlan 3FTOS(conf-if-range-vl-1,vl-3)#FTOS(conf)#interface range tengigabitethernet 2/0 - 23 , tengigabitethernet 2/0 - 23 , tengigab 2/0 - 23FTOS(conf-if-range-te-2/0-23)#FTOS(conf)#interface range tengigabitethernet 2/0 - 23 , tengigab 2/1 - 10FTOS(conf-if-range-te-2/0-23)#FTOS(conf)#inte ra tengig 2/1 - 11 , tengig 2/1 - 23FTOS(conf-if-range-te-2/1-23)#FTOS(conf-if)# interface range tengigabitethernet 5/1 - 23, tengigabitethernet 1/1 - 2FTOS(conf-if-range-te-5/1-23)# no shutdownFTOS(conf-if-range-te-5/1-23)#