Deploying FCoE (FIP Snooping) on Dell Force 10 MXL18Configuring the Cisco 5000 series switch with firmware ver 5.x for a single connection fromthe Dell Force10 MXLCisco Nexus 5000 series configuration sequenceFigure 10.Enable additionalfeaturesConnect CiscoNexus 5000 SeriesSwitchConfigure VSAN(s)and FCoE VLAN(s)feature fcoefeature npivfeature telnetfeature lacpSlot 2port 15-16 type fccopy run startreload - * cautionthis is rebooting theswitch, but is necessaryfor this stepvsan databasevsan 2vlan 1000fcoe vsan 2Configure VFC interfaces forbinding to PortChannelinterface vfc1bind interfaceethernet 1/1no shutdownConfigure VSANdatabase matching VFCand FC interfacesvsan databasevsan 2 interface vfc1vsan 2 interface fc2/15Configure individualports from MXLinterface ethernet 1/1switchport mode trunkswitchport trunk native vlan20switchport trunk allowedvlan 20,1000no shutConfigure zones and zonesetszone name blade1 vsan 2member interface fc2/15member pwwnxx:xx:xx:xx:xx:xx:xx:xxzoneset name set1 vsan 2member blade1zoneset activate name set1 vsan 2Configure FC ports andsettings if using unifiedportsKey Items:CAUTION: The reload step that is necessary for changing the unified ports to FC ports willcause a reboot of the switch and loss of any traffic previously running on the Nexusswitch. This is only applicaple for the Cisco Nexus 5000 Series switches with unified portssuch as the Cisco Nexus 5548UP.
