Deploying FCoE (FIP Snooping) on Dell Force 10 MXL61Flow of additional configuration for FCoE on Cisco Nexus 5000 series switch with vPCFigure 51.Enable additionalfeaturesConnect to firstCisco Nexus 5000Series SwitchConfigure FCports and settingsif using unifiedportsConfigure VSAN(s)and FCoE VLAN(s)feature fcoefeature npivfeature npv – ifneededSlot 2port 15-16 type fccopy run startreload - * cautionthis is rebooting theswitch, but isnecessary for this stepVsandatabasevsan 2Vlan 1000fcoe vsan2Configure VFCinterfaces forbinding toPortChannelinterface vfc1bind interface port-channel20no shutdownConfigure VSANdatabase matching VFCand FC interfacesvsan databasevsan 2 interface vfc1vsan 2 interface fc2/15vsan 2 interface fc2/16Configure individualports for FCoE LAG/PortChannel from MXLinterface ethernet 1/5-6switchport mode trunkswitchport trunk native vlan 20switchport trunk allowed vlan 20,1000channel-group 20 mode activeno shutinterface port-channel20switchport mode trunkswitchport trunk native vlan 20switchport trunk allowed vlan 20,1000no shutdownCreate additional LAG/PortChannel for FCoEconnection from MXLConfigure zones andzonesetszone name blade1 vsan 2member interface fc2/15member pwwnxx:xx:xx:xx:xx:xx:xx:xxzoneset name set1 vsan 2member blade1zoneset activate name set1vsan 2Key Items:CAUTION: The reload step that is necessary for changing the unified ports to FC portswill cause a reboot of the switch and loss of any traffic previously running on theNexus switch.· The additional configuration settings shown in the figure are similar or the same toprevious scenarios. It is simply adding the FCoE settings in on top of the vPCconfiguration already in place.· Note that the VFC interface is bound to the newly added PortChannel from the MXLFCoE connection
