Removing and Installing Parts 131Floppy DriveCAUTION: Before you begin any of the procedures in this section, follow thesafety instructions in the Product Information Guide.CAUTION: To guard against electrical shock, laceration by moving fan blades, orother unexpected injuries, always unplug your computer from the electrical outletbefore opening the cover.NOTE: If you are adding a floppy drive, see "Installing a Floppy Drive" on page 133.Removing a Floppy Drive1 Follow the procedures in "Before You Begin" on page 101.2 Remove the computer cover (see "Removing the Computer Cover" onpage 103).3 Remove the bezel (see "Removing the Bezel" on page 123).4 Remove the CD or DVD drive (see "Removing a CD or DVD Drive" onpage 142).5 Disconnect the power and data cables from the back of the floppy drive.NOTE: If you have installed a PCI Express x16 card, this card may cover thefloppy-drive connectors. Remove this card before disconnecting thefloppy-drive cables (see "Removing a PCI/PCI Express Card" on page 121)6 Disconnect the data cable from the system board.7 Press the two spring clamps and slide out the floppy drive along with theFlexBay drive cage from the FlexBay slot.
