Solving Problems 67Memory ProblemsCAUTION: Before you begin any of the procedures in this section, follow thesafety instructions in the Product Information Guide.FL E X BA Y D E V I C E I S DI S A B L E D —There is a FlexBay disable option in the BIOS setup that appears only when theFlexBay device is installed. If the FlexBay device is physically installed, but it is notrunning, check to see if it is enabled in the BIOS setup.IF Y O U R E C E I V E A N I N S U F F I C I E N T M E M O R Y M E S S A G E —• Save and close any open files and exit any open programs you are not using to see ifthat resolves the problem.• See the software documentation for minimum memory requirements. If necessary,install additional memory (see "Memory Installation Guidelines" on page 112).• Reseat the memory modules (see "Installing Memory" on page 113) to ensure thatyour computer is successfully communicating with the memory.• Run the Dell Diagnostics (see "Starting the Dell Diagnostics From Your HardDrive" on page 84).IF Y O U E X P E R I E N C E O T H E R M E M O R Y P R O B L E M S —• Reseat the memory modules (see "Installing Memory" on page 113) to ensure thatyour computer is successfully communicating with the memory.• Ensure that you are following the memory installation guidelines (see "MemoryInstallation Guidelines" on page 112).• Your computer supports DDR2 memory. For more information about the type ofmemory supported by your computer, see "Memory" on page 167.• Run the Dell Diagnostics (see "Starting the Dell Diagnostics From Your HardDrive" on page 84).
