Back to Contents PagePower SupplyDell™ Inspiron™ One 19 Service ManualRemoving the Power SupplyReplacing the Power SupplyRemoving the Power Supply1. Follow the procedures in Before You Begin.2. Remove the I/O cover (see Removing the I/O Cover).3. Remove the computer stand (see Removing the Computer Stand).4. Remove the optical drive (see Removing the Optical Drive).5. Remove the decorative cover (see Removing the Decorative Cover).6. Remove the speaker cover (see Removing the Speaker Cover).7. Remove the display bezel (see Removing the Display Bezel).8. Remove the back cover (see Removing the Back Cover).9. Remove the I/O bracket (see Removing the I/O Bracket).10. Remove the back metal shield (see Removing the Back Metal Shield).11. Remove the inverter (see Removing the Inverter).12. Remove the system-board shield (see Removing the System-Board Shield).13. Remove the processor heat sink (see Removing the Processor Heat Sink).14. Remove the heat-sink fans (see Removing the Heat-Sink Fans).15. Disconnect the power-supply cable from the connector (PWR_CN1) on the system board. For more information on the location of the power-supplyconnector, see System Board Components.16. Make note of the power-supply cable routing and remove it from the chassis.17. Remove the three screws that secure the power supply to the chassis.18. Place the power supply in a secure location.WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.WARNING: To guard against likelihood of electric shock, laceration by moving fan blades or other unexpected injuries, always unplug yourcomputer from the electrical outlet before removing the computer cover.CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™is not covered by your warranty.CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metalsurface (such as a connector on your computer).