Dell Inspiron One 19 Touch Service Manual

Also see for Inspiron One 19: User guide Setup guide

Back to Contents PageCameraDell™ Inspiron™ One 19 Service ManualRemoving the CameraReplacing the CameraRemoving the Camera1. Follow the procedures in Before You Begin.2. Remove the display bezel (see Removing the Display Bezel).3. Disconnect the camera cable from the connector on the camera module.4. Using a plastic scribe, pry out the camera module to release it from the chassis.5. Lift the camera module off the chassis.Replacing the Camera1. Follow the procedures in Before You Begin.2. Using the glue that shipped with the new camera module, affix the camera module on the chassis.3. Connect the camera cable to the connector on the camera module.4. Replace the display bezel (see Replacing the Display Bezel).5. Connect your computer and all attached devices to electrical outlets, and turn them on.Back to Contents PageWARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™is not covered by your warranty.CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metalsurface (such as a connector on your computer).1 camera 2 camera-cable connectorCAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so mayresult in damage to the computer.