Safety and Regulatory InformationSafety InformationRegulatory InformationNoise Emissions LevelsLaser NoticeEnergy StarSafety InformationCAUTION: Read and follow all safety instructions in your Owner's Manual prior to setting upand operating your printer.Regulatory InformationFederal Communications Commission (FCC) complianceinformation statement (US only)The Dell Workgroup Laser Printer M5200 has been tested and found to comply with the limits for a Class Bdigital device, pursuant to Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)this device may not cause harmful interference, and (2) this device must accept any interference received,including interference that may cause undesired operation.The FCC Class B limits are designed to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses and can radiate radio frequency energy and, if notinstalled and used in accordance with the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in a particular installation. Ifthis equipment does cause harmful interference to radio or television reception, which can be determined byturning the equipment off and on, the user is encouraged to try to correct the interference by one or more ofthe following measures:Reorient or relocate the receiving antenna.Increase the separation between the equipment and receiver.Connect the equipment into an outlet on a circuit different from that to which the receiver isconnected.Consult your point of purchase or service representative for additional suggestions.