the adhesive at least 1 mm (0.04 in.) away from edges. Adhesive material contaminates your printerand could void your warranty.If zone coating of the adhesive is not possible, a 3 mm (0.125 in.) strip should be removed on theleading and driver edge, and a non-oozing adhesive should be used.Remove a 3 mm (0.125 in.) strip from the leading edge to prevent labels from peeling inside theprinter.Portrait orientation is preferred, especially when printing bar codes.Do not use labels that have exposed adhesive.Card stockCard stock is single ply, and has a large array of properties, such as the moisture content, thickness, andtexture, that can significantly affect print quality. See Identifying print media sources and specifications forinformation on the preferred weight for the grain direction of print media.Try a sample of any card stock you are considering using with the printer before purchasing a large quantity.See Print media types and weights for information on the preferred weight of print media.When printing on card stock:Set the Paper Type menu item in the Paper Menu to Card Stock from the operator panel or from theprinter driver.Be aware that preprinting, perforation, and creasing can significantly affect the print quality and causeprint media handling or jamming problems.Avoid using card stock that may release hazardous emissions when heated.Do not use preprinted card stock manufactured with chemicals that may contaminate the printer.Preprinting introduces semi-liquid and volatile components into the printer.We recommend the use of grain short card stock.Storing print mediaUse the following guidelines for proper print media storage. These help avoid print media feeding problemsand uneven print quality:For best results, store print media in an environment where the temperature is approximately 21°C(70°F) and the relative humidity is 40%.Store cartons of print media on a pallet or shelf, rather than directly on the floor.