Dell Networking C9010 Getting Started Manual

Also see for Networking C9010: Installation guide

Contents

switchportTo view the interfaces in Layer 2 mode, enter the show interfaces switchport command in EXECmode.Accessing the System RemotelyYou can configure the switch so that it can be accessed remotely over a Telnet connection.The C9010 system has a dedicated management port and a management routing table that is separatefrom the IP routing table. To configure the system for Telnet access:1. Configure an IP address for the management port.2. Configure a management route with a default gateway.3. Configure a user name and password.Configuring the Management Port IP AddressTo access the system remotely, you must assign IP addresses to the management ports.NOTE: Assign different IP addresses to each RPM management port.1. Enter INTERFACE mode for the Management port.CONFIGURATION modeinterface ManagementEthernet 0/02. Assign an IPv4 or IPv6 address to the interface.INTERFACE modeip address {ipv4-address | ipv6- address}/mask• ip-addressis an address in dotted-decimal format (A.B.C.D).• maskis a subnet mask in /prefix-length format (/ xx).3. Enable the interface.INTERFACE modeno shutdownConfiguring a Management RouteDefine a path from the system to the network from which you are accessing the system remotely.Management routes are separate from IP routes and are only used to manage the system through themanagement port.• Configure an IPv4 or IPv6 management route to the network from which you are accessing thesystem.CONFIGURATION modemanagement route {ipv4-address | ipv6-address}/mask gateway– ip-address is the network address in dotted-decimal format (A.B.C.D).– mask is a subnet mask in /prefix-length format (/ xx).– gateway is the next hop for network traffic originating from the management port.46 Configuring the SoftwareREGULATORY DRAFT 11-4-14