Dell Networking C9010 Getting Started Manual

Also see for Networking C9010: Installation guide

Contents

show vlan vlan-idAssigning Interfaces to a VLANYou can only assign interfaces in Layer 2 mode to a VLAN using the tagged and untagged commands.To place an interface in Layer 2 mode, use the switchport command. A port can be an untaggedmember of a single VLAN or a tagged member of multiple VLANs. When you place an interface in Layer 2mode using the switchport command, the interface is automatically configured as untagged andplaced in the default VLAN.• Tagged ports append an 802.1Q tag to frames on egress and accept only tagged frames on ingress(untagged frames are dropped). You must connect tagged ports to VLAN-aware devices.• Untagged ports do not append an 802.1Q VLAN tag to frames on egress and do not accept taggedframes on ingress (tagged frames are dropped). You must connect untagged ports to VLAN-unawaredevices. To remove an untagged from the default VLAN, remove the switchport configuration.To assign an interface to a VLAN:1. Enter INTERFACE VLAN mode of the VLAN to which you want to assign the interface.CONFIGURATION modeinterface vlan vlan-id2. Assign a switchport interface to a VLAN as a tagged or untagged member.VLAN INTERFACE mode[tagged | untagged] slot/port3. Display all switchport interfaces and the VLANs to which they belong.EXEC Privilege modeshow vlanTo view only the interfaces that are in Layer 2 mode, enter the show interfaces switchportcommand in EXEC Privilege mode or EXEC mode.To move a port interface to another VLAN, add it to the desired VLAN as either a tagged or untaggedmember.Assigning an IP Address to a VLANBecause VLANs are a Layer 2 feature, you must assign an IP address to a VLAN interface in order forphysical interfaces on different VLANs to communicate and route traffic.You cannot assign an IP address to the default VLAN, which, is VLAN 1.The shutdown command in INTERFACE mode does not affect Layer 2 traffic on a VLAN interface.• Configure an IP address and mask on a VLAN interface.VLAN INTERFACE modeip address ip-address mask [secondary]Connecting the Switch to the NetworkAfter you complete the hardware installation and CLI-based software configuration for a C9010 switch,you can connect to a network through the 10/100/1000Base-T RJ-45 management port. If you are using48 Configuring the SoftwareREGULATORY DRAFT 11-4-14