Address Table Commands 101Address Table Commandsbridge addressThe bridge address Interface Configuration (VLAN) mode command adds a MAC-layer stationsource address to the bridge table. Use the no form of this command to delete the MAC address.Syntax• bridge address mac-address {ethernet interface | port-channel port-channel-number} [permanent| delete-on-reset | delete-on-timeout | secure]• no bridge address [mac-address]• mac-address — A valid MAC address.• interface — A valid Ethernet port.• port-channel-number — A valid port-channel number.• permanent — The address can only be deleted by the no bridge address command.• delete-on-reset — The address is deleted after reset.• delete-on-timeout — The address is deleted after "age out" time has expired.• secure — The address is deleted after the port changes mode to unlock learning (no portsecurity command). This parameter is only available when the port is in the learning lockedmode.Default ConfigurationNo static addresses are defined. The default mode for an added address is permanent.Command ModeInterface Configuration (VLAN) mode.User Guidelines• Using the no form of the command without specifying a MAC address deletes all staticMAC addresses belonging to this VLAN.book.book Page 101 Thursday, December 18, 2008 7:40 PM
