522 802.1x CommandsExamplesThe following example sets the number of times that the device sends an EAP-request/identity frame to 6 .dot1x timeout supp-timeoutThe dot1x timeout supp-timeout Interface Configuration mode command sets the time for theretransmission of an Extensible Authentication Protocol (EAP)-request frame to the client. Use the noform of this command to return to the default configuration.Syntax• dot1x timeout supp-timeout seconds• no dot1x timeout supp-timeout• seconds — Time in seconds that the device waits for a response to an EAP-request frame from theclient before resending the request. (Range: 1- 65535 seconds)Default ConfigurationDefault timeout period is 30 seconds.Command ModeInterface configuration (Ethernet) mode.User GuidelinesThe default value of this command should be changed only to adjust for unusual circumstances, such asunreliable links or specific behavioral problems with certain clients. and authentication serversExamplesThe following example sets the timeout period before retransmitting an EAP-request frame to the clientto 3600 seconds.dot1x timeout server-timeoutThe dot1x timeout server-timeout Interface Configuration mode command sets the time that the devicewaits for a response from the authentication server. Use the no form of this command to return to thedefault configuration.Console(config)# interface ethernet 1/e16Console(config-if)# dot1x max-req 6Console(config-if)# dot1x timeout supp-timeout 3600book.book Page 522 Thursday, December 18, 2008 7:40 PM
