Using the CLI 29• SSH Public Key-chain — Contains commands to manually specify other device SSH public keys.The crypto key pubkey-chain ssh Global Configuration mode command is used to enter the SSHPublic Key-chain Configuration mode.• QoS — Contains commands related to service definitions. The qos Global Configuration modecommand is used to enter the QoS services configuration mode.• MAC Access-List— Configures conditions required to allow traffic based on MAC addresses.The IPAL (IP-Access List Configuration) Mode Global Configuration mode command is used toenter the MAC access-list configuration mode.Starting the CLIThe device can be managed over a direct connection to the device console port or via a Telnetconnection. The device is managed by entering command keywords and parameters at the prompt.Using the device command-line interface (CLI) is very similar to entering commands on a UNIX system.If access is via a Telnet connection, ensure that the device has a defined IP address, correspondingmanagement access is granted, and the workstation used to access the device is connected to the deviceprior to using CLI commands.NOTE: The following steps are for use on the console line only.To start using the CLI, perform the following steps:1 Connect the DB9 null-modem or cross over cable to the RS-232 serial port of the device to the RS-232serial port of the terminal or computer running the terminal emulation application.NOTE: The default data rate, for Ryan, is 115,200 (Console port on unit shows a default data rate of 9600).a Set the data format to 8 data bits, 1 stop bit, and no parity.b Set Flow Control to none.c Under Properties, select VT100 for Emulation mode.d Select Terminal keys for Function, Arrow, and Ctrl keys. Ensure that the setting is for Terminalkeys (not Windows keys).CAUTION: When using HyperTerminal with Microsoft® Windows 2000, ensure that Windows® 2000 ServicePack 2 or later is installed. With Windows 2000 Service Pack 2, the arrow keys function properly inHyperTerminal’s VT100 emulation. Go to www.microsoft.com for information on Windows 2000 service packs.For more information, see Dell™ PowerConnect™ 3500 Series User's Guide.2 Enter the following commands to begin the configuration procedure:Console> enableConsole# configureConsole(config)#book.book Page 29 Thursday, December 18, 2008 7:40 PM
