1031•interfaces — The list of interfaces to poll.•sampling-rate— The statistical sampling rate for packet sampling from this source. Asampling rate of 1 counts all packets. A rate of 0 disables sampling. A value of n means thatout of n incoming packets, 1 packet will be sampled. (Range: 1024–65536).•size— The maximum number of bytes that should be copied from the sampler packet(Range: 20–256 bytes).Default ConfigurationThere are no samplers configured by default.The default sampling rate is 0.The default maximum header size is 128.Command ModeGlobal Configuration mode.User GuidelinesThis command has no user guidelines.Exampleconsole(config)#sflow 1 sampling ethernet 1/g2 1500 50sflow sampling (Interface Mode)Use the sflow sampling command in Interface Mode to enable a new sflow sampler instance forthis data source if rcvr_idx is valid. Use the "no" form of this command to reset samplerparameters to the default.Syntaxsflowrcvr-index samplingsampling-rate [size ]no sflowrcvr-index sampling•rcvr-index — The sFlow Receiver for this sFlow sampler to which flow samples are to be sent.If no receiver is configured, then no packets will be sampled. Only active receivers can be set.If a receiver expires, then all samplers associated with the receiver will also expire. (Range: 1 -8).•sampling-rate — The statistical sampling rate for packet sampling from this source. Asampling rate of 1 counts all packets. A rate of 0 disables sampling. A value of n means thatout of n incoming packets, 1 packet will be sampled. (Range: 1024 - 65536).
