287ip igmp snooping querier election participateThis command enables the Snooping Querier to participate in the Querier Election processwhen it discovers the presence of another Querier in the VLAN. When this mode is enabled, ifthe Snooping Querier finds that the other Querier source address is more than the SnoopingQuerier address, it stops sending periodic queries. If the Snooping Querier wins the election,then it continues sending periodic queries. The no form of this command sets the snoopingquerier not to participate in the querier election but to go into a non-querier mode as soon in asit discovers the presence of another querier in the same VLAN.Syntaxip igmp snooping querier election participatevlan-idno ip igmp snooping querier election participatevlan-idDefault ConfigurationThe snooping querier is configured to not participate in the querier election by default.Command ModeVLAN Configuration modeUser GuidelinesThis command has no user guidelines.ExampleThe following example configures the snooping querier to participate in the querier election.console(config-vlan)#ip igmp snooping querier election participateip igmp snooping querier query-intervalThis command sets the IGMP Querier Query Interval time, which is the amount of time inseconds that the switch waits before sending another periodic query. The no form of thiscommand sets the IGMP Querier Query Interval time to its default value.Syntaxip igmp snooping querier query-intervalsecondsno ip igmp snooping querier query-interval•seconds — Amount of time in seconds that the switch waits before sending another generalquery. (Range: 1-1800)
