121Starting the CLITo begin running the CLI, perform the following steps:N O T E : This procedure is for use on the console line only.N O T E : The Easy Setup Wizard is available only when the system is in default state with no userconfiguration saved previously.1. Start the switch and wait until the startup procedure is complete and the User EXEC mode isentered. The promptconsole> is displayed.2. Configure the switch using the Easy Setup Wizard and enter the necessary commands tocomplete the required tasks.3. When finished, exit the session with the quit or exit command.The switch can be managed over a direct connection to the switch console port or through aTelnet connection. If access is through a Telnet connection, the switch must have a defined IPaddress, corresponding management access granted, and a connection to the network.Easy Setup WizardThe Easy Setup Wizard guides the user in the basic initial configuration of a newly installedswitch so that it can be immediately deployed and functional in its basic operation and becompletely manageable through the Web, CLI and the remote Dell Network Manager. Afterinitial setup, the user may enter to the system to set up more advanced configurations.Tunnel From GlobalConfiguration mode,use the interface tunnelcommand.console(config-tunneln)#To exit to GlobalConfigurationmode, use the exitcommand, or press+ toPrivileged EXECmode.Loopback From Globalconfiguration mode, usethe interface loopbackcommand.console(config-loopbackn)#To exit to GlobalConfigurationmode, use the exitcommand, or press+ toPrivileged EXECmode.Command Mode Access Method Command Prompt Exit or AccessPrevious Mode
