172 | Dell PowerConnect W-AirWave Integration and Management Dell PowerConnect W-Series Instant Access Point 6.1.3.1-3.0.0.0 | User GuideThis method describes how to set up a DHCP server to send option 43 with Dell PowerConnect W-AirWaveinformation to Dell Instant IAP. This section assumes that option 43 will be sent per scope since option 60 isbeing shared by other devices as well.1. In server 2008 go to Server Manager > Roles > DHCP Server > Your Domain DHCP Server > IPv4.2. Select a scope (subnet). In the following figure it is 10.169.145.0 (scope 145).3. Right click and select Advanced and choose these options Vendor class— DHCP Standard Options User class— Default User Class Available options— Select 043 Vendor Specific Info String Value— Dell InstantAP, tme-store4, 10.169.240.8, Dell123 (which is the AP description,organization string, Dell PowerConnect W-AirWave IP address, Pre-shared key for Dell PowerConnectW-AirWave).Figure 137 Vendor Specific DHCP optionsOn Dell PowerConnect W-AirWave, the IAP shows up as a new device and a group called tme-store4 has beencreated.Go to APs/Devices > New > Group to view this group.NOTE: This scope should be specific to instant and the PXE devices that use options 60 and 43 should not connect to the subnetdefined by this scope.This is because you can specify only one option 43 for a scope and if other devices that use option 43connect to this subnet, they will be presented with Instant specific information.
