Dell PowerConnect W-Series Instant Access Point 6.1.3.1-3.0.0.0 | User Guide Wireless Network | 53Adding a Voice NetworkThis section provides the procedure to add a voice network.1. In the Networks tab, click the New link. The New Network window appears.Figure 37 Adding a Voice Network— Basic Info Tab2. In the Basic Info tab, perform the following steps:a. Name (SSID)— Enter a name that uniquely identifies a wireless network.b. Primary usage— Select Voice from the Primary usage options. This selection determines whether thenetwork is primarily intended to be used for employee data, guest data, or voice traffic.c. Content filtering— When enabled, all DNS requests to non-corporate domains on this wireless networkare sent to OpenDNS.d. Hide SSID— Select this check box if you do not want the SSID (network name) to be visible to users.e. Band— Set the band at which the network will transmit radio signals. Available options are 2.4 GHz, 5GHz and All. The All option is selected by default. It is also the recommended option.f. Inactivity timeout— Indicates the time in seconds after which an idle client ages out. The minimumvalue is 60 seconds and the default value is 1000 seconds.3. Click the Show advanced options link and perform the following steps.a. Bandwidth Limits— You can specify three types of bandwidth limits. Percentage of Airtime— Indicates the aggregate amount of airtime that all clients on this Network canuse to send/receive data. Each user— Indicates the throughput for any single user on this Network. The throughput value isspecified in kbps. Each radio— Indicates the aggregate amount of throughput each radio (some AP models havemultiple radios) is allowed to provide for all clients connected to that radio.
