Dell PowerConnect W-Series Instant Access Point 6.1.3.1-3.0.0.0 | User Guide Monitoring | 183Usage TrendsThe Usage Trends section displays the following graphs for the selected network: Clients Graph Throughput GraphFor more information about the usage trends graphs in the instant access point view and or monitoringprocedures, see Table 29.Errors The Errors graph shows the errors that occurred whilereceiving the frames for the last 15 minutes. Theerrors are measured in frames per second.To see an enlarged view, click the graph. The enlarged view provides Last, Minimum,Maximum, and Average statistics for the In andOut frames.To see the exact utilization percent at a particulartime, hover the cursor over the graph line.To monitor the errors for the IAP for the last 15minutes,1. Log in to the WebUI. The Virtual Controllerview appears. This is the default view.2. In the Access Points tab, click the name link ofthe IAP for which you want to monitor theerrors. The IAP view appears.3. Study the Errors graph in the RF Trends pane.For example, the graph on the left shows thatthe errors for the IAP at 22:48 hours is 9514.0frames per second.NOTE: You can also click the rectangle icon underthe Errors column in the RF Dashboard pane to seethe Errors graph for the selected IAP.Table 29 Instant Access Point View — Usage Trends and Monitoring ProceduresGraph Name Description Monitoring ProcedureClients The Clients graph shows the number of clientsassociated with the selected IAP for the last 15minutes.To see an enlarged view, click the graph. The enlarged view provides Last, Minimum,Maximum, and Average statistics for the numberof clients associated with the IAP for the last 15minutes.To see the exact number of clients associated with theselected IAP at a particular time, hover the cursorover the graph line.To check the number of clients associated with theIAP for the last 15 minutes,1. Log in to the Instant UI. The Virtual Controllerview appears. This is the default view.2. In the Access Points tab, click the IAP forwhich you want to monitor the clientassociation. The IAP view appears.3. Study the Clients graph in the Usage Trendspane. For example, the graph on the left showsthat one client is associated with the IAP at12:12 hours.Throughput The Throughput graph shows the throughput for theselected IAP for the last 15 minutes. Outgoing traffic — Throughput for outgoing trafficis displayed in green. Outgoing traffic is shownabout the median line. Incoming traffic — Throughput for incomingtraffic is displayed in blue. Incoming traffic isshown below the median line.To see an enlarged view, click the graph. The enlarged view provides Last, Minimum,Maximum, and Average statistics for the incomingand outgoing traffic throughput of the IAP for thelast 15 minutes.To see the exact throughput of the selected IAP at aparticular time, hover the cursor over the graph line.To check the throughput of the selected IAP for thelast 15 minutes,1. Log in to the Instant UI. The Virtual Controllerview appears. This is the default view.2. In the Access Points tab, click the IAP forwhich you want to monitor the throughput. TheIAP view appears.3. Study the Throughput graph in the UsageTrends pane. For example, the graph on the leftshows 4.0 kbps incoming traffic throughput at12:08 hours.Table 28 Instant Access Point View — RF Trends Graphs and Monitoring Procedures (Continued)Graph Name Description Monitoring Procedure
