Stacking | 219Stack Unit in Card-Problem State Due to Incorrect FTOS VersionProblem: A stack unit enters a Card-Problem state because the switch has a different FTOS version thanthe master unit (Figure 17-29). The switch does not come online as a stack unit.Resolution: To restore a stack unit with an incorrect FTOS version as a member unit, disconnect thestacking cables on the switch and install the correct FTOS version. Then add the switch to the stack asdescribed in Adding a Stack Unit. To verify that the problem has been resolved and the stacked switch isback online, use the show system brief command (Figure 17-30).Figure 17-29. Card Problem Error - Different FTOS VersionsFigure 17-30. Card Problem Error - Different FTOS Versions: ResolvedStack Unit in Card-Problem State Due to Configuration MismatchProblem: A stack unit enters a card-problem state because there is a configuration mismatch between thelogical provisioning stored for the stack-unit number on the master switch and the newly added unit withthe same number.Resolution: From the master switch, reload the stack by entering the reload command in EXEC Privilegemode. When the stack comes up, the card problem will be resolvedFTOS#show system briefStack MAC : 00:1e:c9:f1:00:9b-- Stack Info --Unit UnitType Status ReqTyp CurTyp Version Ports------------------------------------------------------------------------------------0 Management online I/O-Aggregator I/O-Aggregator 8-3-17-46 561 Standby card problem I/O-Aggregator unknown 562 Member not present3 Member not present4 Member not present5 Member not presentFTOS#show system briefStack MAC : 00:1e:c9:f1:04:82-- Stack Info --Unit UnitType Status ReqTyp CurTyp Version Ports------------------------------------------------------------------------------------0 Management online I/O-Aggregator I/O-Aggregator 8-3-17-52 561 Standby online I/O-Aggregator I/O-Aggregator 8-3-17-52 562 Member not present3 Member not present4 Member not present5 Member not present
