Ethernet Configuration Commands 401When you use the no storm-control multicast command to "disable" storm-control after having set the level or rate to a non-default value, that value isstill set but is not active until you re-enable storm-control.Syntaxstorm-control multicast [level |rate]no storm-control multicast• level— The configured rate as a percentage of link-speed.•rate — The configured rate in kilobits per second (kbps). (Range: 0-100)Default ConfigurationThe default value is 5.Command ModeInterface Configuration (Ethernet) modeUser GuidelinesThis command has no user guidelines.Exampleconsole(config-if-1/0/1)#storm-control multicastlevel 5storm-control unicastUse the storm-control unicast command in Interface Configuration mode toenable unknown unicast storm control for an interface. If the mode isenabled, unicast storm recovery is active, and if the rate of unknown L2unicast (destination lookup failure) traffic ingressing on an interface increasesbeyond the configured threshold, the traffic will be dropped. Therefore, therate of unknown unicast traffic will be limited to the configured threshold.When you use the no storm-control multicast command to "disable" storm-control after having set the level or rate to a non-default value, that value isstill set but is not active until you re-enable storm-control.
