System Board Information 3317System Board InformationBlade System Board Jumper SettingsCAUTION: Many repairs may only be done by a certified service technician. Youshould only perform troubleshooting and simple repairs as authorized in yourproduct documentation, or as directed by the online or telephone service andsupport team. Damage due to servicing that is not authorized by Dell is not coveredby your warranty. Read and follow the safety instructions that came with theproduct.PowerEdge M915 Jumper SettingsFigure 7-1 shows the location of the configuration jumpers on the bladesystem board. Table 7-1 lists the jumper settings.NOTE: Figure 7-1 is oriented with the front end of the blade system board facing tothe right.Table 7-1. PowerEdge M915 Jumper SettingsPWRD_EN (default) The password feature is enabled.The password feature is disabled.NVRAM_CLR (default) The configuration settings are retained atsystem boot.The configuration settings are cleared at thenext system boot. (If the configuration settingsbecome corrupted to the point where thesystem does not boot, install the jumper andboot the system. Remove the jumper beforerestoring the configuration information.)
