8System MessagesLCD MessagesNOTE: Applicable only if your system has an LCD display.The LCD messages consist of brief text messages that refer to events recorded in the System Event Log (SEL). Forinformation on the SEL and configuring system management settings, see the systems management softwaredocumentation.NOTE: If your system fails to boot, press the System ID button for at least 5 seconds until an error code is displayedon the LCD. Record the code, then see System Error Messages.Viewing LCD MessagesIf a system error occurs, the LCD screen will turn amber. Press the Select button to view the list of errors or statusmessages. Use the Left and Right buttons to highlight an error number, and press the Select button to view the error.Removing LCD MessagesFor faults associated with sensors, such as temperature, voltage, fans, and so on, the LCD message is automaticallyremoved when that sensor returns to a normal state. For other faults, you must take action to remove the message fromthe display:• Clear the SEL — You can perform this task remotely, but you will lose the event history for the system.• Power cycle — Turn off the system and disconnect it from the electrical outlet; wait approximately 10 seconds,reconnect the power cable, and restart the system.System Error MessagesSystem messages appear on the monitor to notify you of a possible problem with the system. These messages refer toevents recorded in the System Event Log (SEL). For information on the SEL and configuring system management settings,see the systems management software documentation.Some messages are also displayed in an abbreviated form on the system's LCD, if the system includes that feature.NOTE: The LCD error messages listed here are displayed in the simple format. See Setup Menu to select the formatin which the messages are displayed.NOTE: If you receive a system message not listed here, check the documentation of the application that wasrunning when the message was displayed or the operating system's documentation for an explanation of themessage and recommended action.NOTE: In some messages, a particular system component is identified by name (“”) component number(“”), or location (“bay”).125
