NOTE: Retain removed memory-module blank(s) for future use.6. Align the memory-module's edge connector with the alignment key of the memory-module socket, and insert thememory module in the socket.NOTE: The memory-module socket has an alignment key that allows you to install the memory module in thesocket in only one orientation.CAUTION: To prevent damage to the memory-module socket during installation, apply pressure at both endsof the memory module evenly. Do not apply pressure to the center of the memory module.7. Press down on the memory module with your thumbs until the memory module snaps into place.Figure 18. Installing The Memory Module1. memory module2. memory-module ejectors3. memory-module socket alignment key4. memory-module alignment keyNOTE: When the memory module is properly seated in the socket, the levers on the memory-module socketalign with the levers on the other identical sockets that have memory modules installed.8. Repeat step 4 through step 7 of this procedure to install the remaining memory modules.9. Replace the cooling shroud.10. Close the system.11. Reconnect the system to its electrical outlet and turn on the system, including any attached peripherals.12. Press to enter the System Setup, and check the memory settings.The system should have already changed the value to reflect the newly installed memory.13. If the value is incorrect, one or more of the memory modules may not be installed properly. Repeat step 4 throughstep 7 of this procedure, checking to ensure that the memory modules are firmly seated in their sockets.14. Run the appropriate diagnostic test. For more information, see Using System Diagnostics.Hard DrivesDepending on the configuration, your system supports one of the following:49
